One-support saw 1600 - 2000 mm of PW1TK 1600 type
- version without table
- engine with spindle and belt gear 30 kW
- bridge driving on walls
- Single cut in automatic cycle
- fluent regulation of movement in axes X,Y (frequency inverter 1,5 kW)
- plastic cable guide with profile leading to media supply
- in axis X (on bridge) and Y (on walls)
- Limit switch limiting movement on Y axis (on walls)
- electronic acceleration and braking as well as fluent regulation of disc regulation(frequency inverter ) 30 kW
Accessories for one-support saw:
| electronic measurement of movement (by CLED) – manual cycle with accuracy +- (0.5 + 0.03 x L) mm L in m, automatic cutting for „strips” to 5 pieces, with any programmed width, repeatable 99 times with accuracy to +-(0.5 +0.4 + 0.03 x L) mm |
| Reinforced track made of double-tee bar (regulation on screws) |
| Remote control on spiral cable X , Y , Z |
| pneumatic blockade of bridge during cutting |
| analog amperometer |
| pulpit on lifting arm |
| paint |
| water pressure sensor |
| Spindle engine 30 kW 700 rev./min (extra charge) |
Switch board, right or left side
Requirements to be executed (before starting the machine) by Customer:
- electric supply cable:
5 x 10 [mm2] ,copper line (flexible)
- protection in electric network before machine
3 x 63 A
- before start, all fixed, metal parts shall be connected by means of band iron of section 120 mm2 with PE of electric installation.
- all media (electricity, water, compressed air) shall be led to foundations of switch board.
- Along foundation, from side of switch board it is necessary to build bridge for machine operator.
- The obligation of saw purchaser is to mount main circuit breaker 100A in a casing on the wall in a place approachable
