/ Current Offer / ONE-SUPPORT SAWS / One-support saw 1200 mm type PW1TK 1200

One-support saw 1200 mm type PW1TK 1200

table blockade 0 , 90 degrees
single cutting in automatic cycle
fluent regulation of feed speed in axes X,Y (frequency inverter 1,5 kW)
plastic guide of cables with profile leading to media supply in axes X (on the bridge) and Y (on the walls)
Limit switch limiting the movement over axis Y (on walls)

Extra charge

18,5kW

6 pol

22kW

8 pol

30kW

8 pol

Disc mounted on engine’s shaft

Electronic acceleration and braking and fluent regulation of disc revolutions (frequency inverter)

Accessories of one-support saw:

Laser attached

Remote control on spiral cable

Display of an angle of table inclination to 0,025 degree

Table blocking in each position

Reinforced track made of double-tee bar (regulation on screws)

Electronic measurement of translocation (on counter CLED) – in manual cycle with accuracy +/-0.5 + 0.03 x L) mm L in m,, automatic cutting of belts (programmed width) to 5 pieces of any programmed width, repeatable 99 times, with accuracy to +- ((0.5 +0.4 + 0.03 x L) mm )L in m

Bellows shield on a guide on bridge or oil basin

Pneumatic blockade of bridge during cutting

Precise turning device of table

Rotating table, lowered pneumatically (for thin plates 300 kg)

Pulpit on lifting arm

paint

Water pressure sensor

Elekctro-valve

Requirements to be executed (before starting the machine) by Customer:

electric supply cable:
5 x 10 [mm2] , copper line (flexible)
protection in electric network before machine
3 x 40 to 63 [A]
before start, all fixed, metal parts shall be connected by means of band iron of section 120 mm2 with PE of electric installation.
all media (electricity, water, compressed air) shall be led to foundations of switch board.
Along foundation, from side of switch board it is necessary to build bridge for machine operator.
The obligation of saw purchaser is to mount main circuit breaker 100A in a casing on the wall in a place approachable