| Extra charges | 7,5 kW 4 pol | 11 kW 4 pol | 15 kW 6 pol | 18,5 kW 6 pol |
| Disc mounted on engine’s shaft | ||||
| Electronic acceleration, braking and fluent regulation of revolutions on disc (frequency inverter) | ||||
| Electronic disc acceleration (soft-start) |
Accessories of one-support saw:
| Laser attached |
| Remote control on spiral cable X ,Y , Z |
| Display of an angle of table inclination to 0,025 degree. |
| Table blocking in each position |
| Electronic measurement of translocation (on counter CLED) – in manual cycle with accuracy +- ((0.5 +0.4 + 0.03 x L) mm )L in m, automatic cutting of belts (programmed width) to 5 pieces of any programmed width, repeatable 99 times, with accuracy to +- ((0.5 +0.4 + 0.03 x L) mm )L in m |
| Reinforced frame |
| Reinforced track made of double-tee bar (regulation on screws) |
| Bellows shield on a guide on bridge or oil basin |
| Pneumatic blockade of bridge during cutting |
| Precise turning device of table |
| Rotating table, lowered pneumatically (for thin plates 300 kg) |
| Support inclinable electrically to 45º. Gear of support turning with internal nut. |
| Analog amperometer |
| Pulpit on lifting arm |
| paint |
| Water pressure sensor |
| Elektro valve |
Steering box right or left side
Requirements to be executed (before starting the machine) by Customer:
The obligation of saw purchaser is to mount main circuit breaker 63A in a casing on the wall in a place approachable
for disc over 900 mm along foundations from the side of switch board it is necessary to build bridge for machine operation
