The device is used to:
cut and format plates of maximum thickness depending on disc diameter and power of main engin. Working area 3,00 m x 3,00 m.
touchable panel to driver with possibility of process visualization eg. display of an angle of support inclination, displacement of axis X and Z.
up-down of support (axis Z), support inclination (axis B) are controlled by another three-phase wave converter
single cutting in automatic cycle,
table blockade 0 - 45- 90 degrees,
fluent regulation of feed speed in axes X,Y (frequency inverter 1,5 kW)
translocations on ball-rolling guides
limit switches limiting movement on walls
plastic guide of cables with a profile leading to electric and water supply:
disc mounted on motor’s shaft 9 kW
bellows shield on a guide on bridge or oil basin
| Extra charges |
9 kW 4 pol |
11 kW 6 pol |
15 kW 6 pol |
18,5 kW 8 pol |
| Disc mounted on engine’s shaft | standard | |||
| Electronic acceleration and braking as well as fluent regulation of disc turns (wave converter) |
Accessories:
| Laser attached |
| Cutting out spatial shapes in upper part of plate, machine reads – by means of a laser sensor – drawing on panel |
| Relay of stop XPS |
| Remote control on spiral cable X Y Z |
| Rotating table blocked 45°-90° |
| Table blockade in each position |
| Reinforced frame |
| Track enforced made of double-tee regulation on screws |
| Bellows shield on a guide over the bridge or oil basin |
| Pneumatic blockade of bridge during cutting |
| Precise turning device of table |
| Rotating table, lowered pneumatically (for thin plates 300 kg) |
| Pulpit on swinging arm |
| Construction lacquer |
| Water pressure sensor |
| Electro-valve |
Switch board right or left side
Requirements to be executed (before starting the machine) by Customer:
The obligation of saw purchaser is to mount main circuit breaker 63A in a casing on the wall in a place approachable
