/ Current Offer / TWO-SUPPORT SAWS / Two-support saw of PP2TK 600.2 type

Two-support saw of PP2TK 600.2 type

table blockade 45-90 degrees,
supports inclinable electrically till 45 degrees,
programmed selection of cutting marble and granite,
fluent regulation of feed speed in axes X, Y, Z (3 x wave converter),
Steering box made of stainless steel
operator’s programs of machine entered in driver PLC cooperating with touchable operator’s panel (to enter work parameters),
increased speed of translocations in axis X to 2m/min automat and 4 m/min and manual cycle in relation to PP2TK 600.1
individual, bottom level of „cut to end” for each support
plastic guide of cables with profile leading to supply: electric and water in axis X (on bridge), Y (on walls), Z (up down)
electronic measurement of feed in manual cycle of each support and distance between them with accuracy to +-2 (0.5 +0.2 + 0.03 x L) mm L in m.
automatic cutting on „belts – programmed width” to 5 pieces, at any programmed any width repeatable 99 times for each support with accuracy to +-( 0.5+ 0.2 + 0.03 x L) mm L in m
measurement in axis Z (encoder)

Extra charge	9 kW 4 pol	11 kW 4 pol	15 kW 6 pol
Disc mounted on engine’s shaft
Electronic acceleration and braking as well as fluent regulation of disc revolutions (2 x wave converter)
Electronic acceleration of discs (2 x soft-start)

Accessories to two-support saw:

2 attached lasers

Display of work parameters of main engines on panel (revolutions, current)

Remote control on spiral cable X ,Y ,Z

Display of an angle of table inclination to 0,25 degree.

Blockade of table in each position

Reinforced track made of double-tee bar (regulation on screws)

Rotating table, lowered pneumatically (for thin plates 300 kg)

Supports for disc 800 mm

Cutting out profiles from plates by each saw individually acc. to templates (programs: marble and granite profiles)

Cutting vases or columns by each saw individually acc. to templates (programs: column marble and granite) 1 set to fasten columns

Display of an angle of inclination of supports

Analog amperometer 2 pieces (in case of lack of wave converter)

Pulpit on lifting arm

Structural paint

Non-standard production of bridge

Water pressure sensor

Electro-valve (2 pieces)

Switch board, right or left side

Requirements to be executed (before starting the machine) by Customer:

electric supply cable:
5 x 6 [mm2]
protection in electric network before machine
C32 – 3P
before start, all fixed, metal parts shall be connected by means of band iron of section 120 mm2 with PE of electric installation.
all media (electricity, water, compressed air) shall be led to foundations of switch board.

The obligation of saw purchaser is to mount main circuit breaker 63A in a casing on the wall in a place approachable
for disc over 750 mm along foundations from the side of switch board it is necessary to build bridge for machine operation